Female and Male Cones

Female Cone
Female Cone, CO-F-SM
Male Cone
Male Cone, CO-60-CPM

When the surface of a Male Cone is brought into contact with the circle formed at the intersection of a hole and a plane, three degrees of test part freedom are constrained. Two side by side Cones will form an excellent Vee Block to restrict two degrees of test part freedom. The smallest Male Cone (Part #CO-60-CPM ) has a 60 degree included angle, so that it is compatible with the standard shaft centers. It starts at a sharp point and goes up to one inch ( 2.54 cm ) diameter. This small Cone is made of hardened stainless steel and the Cone is precision ground. This smallest of the conical component uses the standard one-half inch (1.27cm) diameter boss with a #10-32 hold down thread to form a high load carrying joint. Another small diameter hardened stainless steel Male Cone, ( Part #CO-90-CPM ) has a 90 degree included angle. The 90 degree angle starts at a one-eighth inch ( 0.125", 0.32 cm) diameter flat tip and goes up to the full one inch ( 2.54 cm ) diameter. This Male Cone is precision ground. It has the standard one-half inch (0.50", 1.27cm) diameter boss ( post ) with a #10-32 hold down to provide high load carrying capacity.

Male Cones
Downloads
Part # PDF Solidworks IGES
CO-60-CPM Download as PDF Download as Solidworks Download as IGES
CO-90-CPM Download as PDF Download as Solidworks Download as IGES
CO-90-CPM-SHARP Download as PDF Download as Solidworks Download as IGES

 

Female Cones
Downloads
Part # PDF Solidworks IGES
CO-F-SM Download as PDF Download as Solidworks Download as IGES
CO-F-CPM Download as PDF Download as Solidworks Download as IGES
Male Cone
Male Cone, Cylindrical Post Mounted, 60°, 1" Diameter Part No.: CO-60-CPM
Male Cone, 90 degrees
Male Cone, Cylindrical Post Mounted, 90°, 1" Diameter Part No.: CO-90-CPM
Female Cone, Surface Mounted
Female Cone, Surface Mounted 1.125" Diameter Part No.: CO-F-SM
Female Cone, Post Mounted
Female Cone, Post Mounted 1.125" Diameter Part No.: CO-F-CPM
Bal-Tec Logo
Phone:
323.582.7348
800.322.5832
Fax:
323.582.0934